EMC ESD problems

EMC ESD problems

Postby GiovanniTEIS » Wed Jun 03, 2015 5:08 pm

PIC32MX460F512L

I develop some different products using the microcontroller PIC32MX460F512L. All the products are affected by problems with the ESD discharge test EN 61000-4-2.
When arrive a discharge, the microcontroller perform a reset. It happen also using a coupling plane near to the microcontroller, without allow to the discharge to direct arrive to the board.
On the board are present a Transil on the 3V3 and all the requested ceramic capacitor.
It's not easy to solve the problem because there isn't a particular problematic pin, the ESD arrive only at the external test plane.

Any Idea or official guide about this ESD problem ?
GiovanniTEIS
 
Posts: 1
Joined: Wed Jun 03, 2015 4:47 pm
PIC experience: Professional 5+ years with MCHP products

Re: EMC ESD problems

Postby ric » Thu Jun 04, 2015 5:49 am

What is conmected to your MCLR pin (even if it is disabled)
Are all your pins either tied high/low, or set to output?
Do you have a bypass capacitor mounted as close as possible to every pair of power pins?
Latest test project, an LED matrix display made from one reel of addressable LEDs. here
User avatar
ric
Verified identity
 
Posts: 398
Joined: Sat May 24, 2014 2:35 pm
Location: Melbourne, Australia
PIC experience: Professional 5+ years with MCHP products


Return to PIC32 topics

Who is online

Users browsing this forum: No registered users and 2 guests