PICKIT 3 problem

(instructions, reset, WDT, specifications...) PIC17Cxx, PIC18Fxxx

PICKIT 3 problem

Postby larny » Tue Apr 30, 2019 12:06 am

I bought a PK3 some months ago & used it to programme a 16F1708 via MPLAB 8.2.
(I have MPLAB X but have not worked out how the use it fully).
But yesterday, I tried to use PK3 again to do another 16F1708 and received the "Target device ID (0x0) does not match ......0" message.
I connected my scope to the Vpp (without the PIC installed) and found it was only 4.4 Volt rather than the required 8 ~ 9 Volt. I checked the hardware and it was OK.
I also tried to programme a 12F675 but received the same message.
Any advice will be appreciated.
larny
 
Posts: 4
Joined: Thu Oct 23, 2014 5:36 am
Location: Melbourne Australia
PIC experience: Experienced Hobbyist

Re: PICKIT 3 problem

Postby AussieSusan » Wed May 01, 2019 3:17 am

See my reply to this question at https://www.edaboard.com/showthread.php ... g-PICKIT-3
Susan
AussieSusan
Verified identity
 
Posts: 173
Joined: Mon Jun 16, 2014 4:45 am
PIC experience: Experienced Hobbyist


Return to 16-Bit Core

Who is online

Users browsing this forum: No registered users and 8 guests

cron